MX Linux Forum

Finally, I can report : success ! Unbound is now running on a raspberry pi 3 B+, connected with ethernet-cable (gigabit-LAN) to my router. It does the whole internet traffic of my home-network using DNS-over-TLS, and is working real fast. Could solve my printer-problem: I had to add printer-name and...

Still no success. As far as I understand the operating principle of unbound, the whole internet traffic is done by using the "localhost-interface", which is IP 127.0.0.1. The setup of my network-printer was done by CUPS, which uses the localhost-interface, too. So I guess, this is the poin...

Well, i have to report one issue, which is not solved yet: unbound is running well, but I cannot acces my network-printer (brother-MFC-J480DW) any more. Think I have to configure local-zones and private-adresses, which had left out in my unbound.conf. Still reading and learning about that. Will repo...

Okay, here is my report: installing unbound After install I did the following: to get a recent list of primary DNS-servers, I used this command : „wget https://www.internic.net/domain/named.root -O /etc/unbound/root.hints“ , next command : „unbound-anchor“ , to verify the root-anchors. Then I change...

Hello Stevo, I give a first short report: unbound is installed on my Acer Travelmate and running well! Internet traffic is running exclusively over unbound, TLS-encryption works. Start-command is in autostart-folder and it works. For now, I'm happy. Will do some more testing and send a more detailed...

I will do. Again, thank you very much! That was an extremely fast work!

Tkank you very much, Stevo!

Hello community! I plan to install UNBOUND as my local DNS-Resolver, so I can connect to my selected public DNS-servers via DNS over TLS. I believe, this is a good step to get more privacy and security when browsing the net. The actual version (1.6.3) has some severe bugs and is almost unusable. Tha...

Hallo Deutsches Forum!
Zur Frage : stimmt genau, wie Eadwine Rose es beschrieben hat: wenn Du den Stick z.B. mit Gparted bearbeiten willst (formatieren oder partitionieren), muss!! er ausgehängt sein (unmounted). Wann immer Du in herausziehen willst, immer auswerfen.
Gruß aus Niedersachsen!

Just updated to last Firefox 59-version and recognized: german language pack doesn't work. This is widely reported in several forums. Here's a workaround (from an Arch-Linux forum). Works on my MX16 and MX17 machines : https://bbs.archlinux.org/viewtopic.php?pid=1773834#p1773834 Greetings from Lower...